模型:IKPS-60系列,en	 
筆記:	Universal AC input 90~264Vac
High Efficiency, low power consumption
Output protections: SCP/OVP/ OLP/OPP
Wide operating ambient temperature (-25℃~70℃)
All using 105℃long life electrolytic capacitors.
100% full load burn-in test
| MODEL | IKPS-60-5 | IKPS-60-12 | IKPS-60-15 | IKPS-60-24 | IKPS-60-48 | ||
| OUTPUT | DC Output | 5.0V | 12.0V | 15.0V | 24.0V | 48.0V | |
| Rated Current | 8.0一個 | 4.5一個 | 3.6一個 | 2.5 一個 | 1.25一個 | ||
| Ripple and Noise Note 2 | 0~70℃ | <50mV | <120mV | <150mV | <240mV | <240mV | |
| -25℃~0℃ | <200mV | <200mV | <150mV | <240mV | <240mV | ||
| Voltage ADJ. Range | -5% ~ +10% of rated voltage | ||||||
| Voltage Accuracy | ±3.0% | ||||||
| 線路調整 | ±0.5% | ||||||
| 負載調節 | ±2.0% | ||||||
| Set-up Time | ≤1.0S (230Vac input, Full load) | ||||||
| Hold up Time | ≥20mS(230Vac input, Full load) | ||||||
| Temperature Coefficient | ±0.03%/℃ | ||||||
| Overshoot and Undershoot | <5.0% | ||||||
| INPUT | VoltageRange Note 3 | 90Vac~264Vac, 127Vdc~370Vdc | |||||
| FrequencyRange | 47Hz-63Hz | ||||||
| Efficiency ( Typical) | 81% | 84% | 84% | 86% | 87% | ||
| AC Current (最大。) | <1.5一個 | ||||||
| Inrush Current (Typical) | <30A@120Vac <60A@230Vac Cold start | ||||||
| Leakage Current | <0.25mA | ||||||
| PROTECTION | Over Load | 105%~180% of rated output current, hiccup mode, auto recovery | |||||
| Over Power | 105%~180% of rated output power, hiccup mode, auto recovery | ||||||
| Over Voltage | 105%~150%的額定輸出電壓,,en,恆壓,,en,短路,,en,長期模式,,en,環境,,en,經營,,ca,溫度,,en,哼,,en,~90%RH無冷凝,,en,參考降額曲線,,en,儲存溫度,,en,℃〜85℃,,en,~95%RH無冷凝,,en,安全,,en,EMC,,en,安全標準,,en,UL60950-1,,en,ND,,en,埃德,,en,EN60950-1,,zh-CN,耐壓,,en,主次,,en,KVAC,,en,≤,,en,mA .Primary-PG,,en,毫安,,ar,二次PG,,en,KVDC,,en,隔離電阻,,en,≥,,en,M歐姆,,en,EMC排放,,en,符合EN55022,EN55024 ClassB標準,,en,諧波電流,,en,符合EN61000-3-2,-3,,en,EMC抗擾度,,en,符合EN61000-4-2,3,4,5,6,8,11,,en,EN55024,EN61000-6-2重工業水平,,en,其他,,en,MIL-HDBK-217F,,es,超過200,000小時,,en,L * W * H,,en,×51×28.8毫米,,en,冷卻方式,,en,注意,,en,未特別提及的所有參數均在230Vac輸入下測量,,en,額定負載和25℃的環境溫度,,en,通過使用端接有端子的12“雙絞線,在20MHz的帶寬下測量,,en,uF的,,en,uF並聯電容器,,en, Constant voltage | ||||||
| Shorted Circuit | Long-term mode, auto recovery | ||||||
| ENVIRONMENT | Operating amb. Temp. & Hum. | -25℃~70℃; 20%~90%RH No condensing (refer to the derating curve) | |||||
| Storage Temp. & Hum. | -30℃~85℃; 10%~95%RH No condensing | ||||||
| SAFETY &EMC (Note 4) | Safety Standards | UL60950-1; EN60950-1:2006 | |||||
| Withstand Voltage | Primary-Secondary:3.0KVac; ≤10mA . | ||||||
| Isolation Resistance | ≥100M ohms | ||||||
| EMI Conduction&Radiation | Compliance to EN55022, FCC PRAT15 B Class B | ||||||
| Harmonic Current | Compliance to EN61000-3-2,-3 | ||||||
| EMSImmunity | Compliance to EN61000-4-2,3,4,5,6,8,11; heavy industry level | ||||||
| OTHERS | MTBF (MIL-HDBK-217F) | More than 200,000Hrs (25℃, Full load) MIL-217 Method 2 Components Stress Method | |||||
| Dimension (L*W*H) | 101.6×50.8×30mm | ||||||
| Packing | |||||||
| Cooling method | Cooling by free air convection | ||||||
| NOTE | 1.All parameters NOT specially mentioned are measured at rated input, rated load and 25℃ of ambient temperature. 2.Measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1 uF & 10uF parallel capacitor. 3. The power supply is considered as a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. | ||||||
